SellPix AISocial

Carbon Monoxide Alarm Check Before the Clocks Fall Back

A five-minute carbon monoxide alarm check for the November 1 clock change: where alarms go, how to test them, when to swap batteries, and when the whole unit needs replacing.

SellPix Social9 min readPublished

Quick answer: Before the clocks fall back on Sunday, November 1, 2026, test every carbon monoxide alarm, check its battery, and read the replace-by date on the back. CDC suggests checking CO detector batteries at each spring and fall clock change, CPSC adds a monthly test and a fresh battery every year, and an alarm past its date gets replaced, not repaired.

SellPix Social earns a commission from qualifying purchases made through links marked “Paid link”, at no extra cost to you. As an Amazon Associate I earn from qualifying purchases.

On this page

Quick answer: Before the clocks fall back on Sunday, November 1, 2026, test every carbon monoxide alarm, check its battery, and read the replace-by date on the back. CDC suggests checking CO detector batteries at each spring and fall clock change, CPSC adds a monthly test and a fresh battery every year, and an alarm past its date gets replaced, not repaired.

Kidde C3010D carbon monoxide alarmImage: Kidde

Pictured: Kidde C3010D carbon monoxide alarm. Manufacturer's product image, not our photograph or test. Other models discussed in this article are not pictured.

Diagram of a two-story house showing carbon monoxide alarms outside the bedrooms and on each levelChart

Carbon monoxide has no smell and no color, so the alarm is the only warning most homes get. CDC counts more than 400 Americans who die each year from unintentional CO poisoning not linked to fires, and more than 100,000 emergency department visits. The check below takes about five minutes per alarm. This is a research guide built from CDC, CPSC and NFPA guidance plus maker documentation; we did not lab-test any alarm.

Who should do this check

  • Any home with fuel-burning equipment: a gas or oil furnace, water heater, range, dryer, fireplace or wood stove.
  • Homes with an attached garage, even if everything inside is electric. Car exhaust can reach the house.
  • Anyone who uses a portable generator during outages. CDC says to use a battery-powered or battery backup CO detector in the home whenever a generator runs.
  • Renters: your lease and local code decide who installs the alarm, but the monthly test takes ten seconds and anyone can do it.

Skip nothing because the alarm "seems fine." A carbon monoxide alarm can sit silent for years and still be past its working life.

Where a carbon monoxide alarm should go

CPSC says CO alarms belong on each level of the home and outside sleeping areas. NFPA puts them in a central spot outside each separate sleeping area and on every level, and recommends interconnecting them so that when one sounds, they all sound. CDC asks for battery-operated or battery backup detectors near every sleeping area.

Spot Alarm? Why
Hallway outside bedrooms Yes The core CPSC, NFPA and CDC placement
Each additional level Yes CPSC and NFPA: every level of the home
Bedrooms far apart One per sleeping area NFPA: each separate sleeping area
Basement with no bedroom Follow the manual CPSC says attics and basements are not needed unless someone sleeps there; Kidde suggests extra alarms on levels with fuel-burning equipment
Next to the furnace or water heater Not right beside it Kidde's US placement guide puts extra alarms 5 to 20 feet from sources such as a furnace, water heater or fireplace; your manual sets the exact gap
Next to a window, door or in a dead-air corner No Kidde: do not place the unit in dead air spaces or next to a window or door
Attic No CPSC: not unless it includes a sleeping area

Mounting height and the minimum distance from cooking and heating appliances differ between models. The printed manual for your alarm is the final word.

The five-minute clock-change check

Five-step carbon monoxide alarm checklist for the fall clock change: test, power, date, sounds, furnace serviceChart

  1. Press and hold the test button until the horn sounds. NFPA and CPSC both ask for a monthly test, not just twice a year. No sound means the alarm needs power or replacing.
  2. Check the power. For an alarm with a replaceable battery, fit a new one; CPSC recommends replacing smoke and CO alarm batteries every year. For a plug-in alarm, confirm the power light is on and the backup battery is fresh. A sealed 10-year alarm has no battery to change.
  3. Read the date label on the back. CDC says to replace your CO detector following the manufacturer's instructions, or every 5 years if you have nothing else to go on. Write the replace-by date on the alarm with a marker and add it to your phone calendar.
  4. Learn the sounds. The manual lists the CO alarm pattern, the low-battery chirp and the end-of-life signal. Make sure everyone in the house knows which one means "get out now."
  5. Book the yearly furnace service. CDC recommends a qualified technician check your heating system, water heater and any other gas, oil or coal burning appliances every year, and a chimney check or cleaning every year.

If your carbon monoxide alarm goes off

NFPA's instruction is short: move immediately to fresh air, outdoors or at an open window or door, make sure everyone is accounted for, and call for help from that fresh-air spot. Stay there until emergency responders arrive. Do not go back in to find the source, and do not silence the alarm and wait.

CDC lists the most common symptoms of CO poisoning as headache, dizziness, weakness, upset stomach, vomiting, chest pain and confusion, often described as "flu-like." People who are asleep can be overcome before they notice anything, which is why the alarm placement near bedrooms matters most.

NFPA also suggests calling your local fire department's non-emergency number ahead of time to find out which number they want you to call when a CO alarm sounds.

Replacing an expired alarm: two common types

If the date label has passed or the test fails, here are two widely sold styles. Both use an electrochemical sensor and an 85-decibel horn, per their Amazon listings checked October 17, 2026. Prices change often, so check the current price on the listing.

Plug-in with battery backup: First Alert CO606 . First Alert and this Amazon listing label the alarm CO606, and First Alert's page also still calls it CO605, so you may see either code. It plugs into a standard outlet and keeps working on a 9V backup battery during a power outage. The listing gives a 7-year limited warranty and an end-of-life chirp that tells you when to replace the unit, and a low-battery mute of up to 8 hours. Good for a hallway with a free outlet near the bedrooms. Skip it if the only outlet there is behind furniture or switched off by a wall switch, since the alarm then runs on backup alone.

Sealed 10-year battery with a display: Kidde C3010D . A lithium battery sealed in for 10 years, so there is no battery to replace and it keeps working through outages. The digital display updates every 15 seconds, a peak-level memory shows the highest reading, and an amber light means "replace the detector." It mounts on a wall or sits on a shelf. CDC suggests considering a detector with a digital readout because it can show the highest CO level in your home. The trade-off: when the 10 years are up, the whole unit goes.

Neither type replaces a smoke alarm. Standard smoke alarms do not detect CO, so you need both, or a combination smoke and CO alarm installed where smoke alarms belong.

Other winter CO risks the alarm cannot fix

  • Generators: CDC says never run one inside the home or garage, even with doors and windows open, and keep it more than 20 feet from windows, doors and vents.
  • Cars: never run a car or truck inside an attached garage, even with the door open.
  • Ovens and grills: never heat the house with a gas oven, and never burn charcoal indoors.
  • Vents and chimneys: make sure gas appliances vent properly, and have the chimney checked or cleaned every year.

If winter outages are a worry, our NOCO Boost GB40 jump starter guide covers cold-weather car prep, and the Bedsure heated throw guide looks at an electric throw for cold evenings.

FAQ

How often should I test a carbon monoxide alarm?

Once a month. NFPA and CPSC both say to test CO alarms monthly. The spring and fall clock changes are a good reminder to also check or replace the battery.

How long does a carbon monoxide alarm last?

Follow the date on the alarm. CDC says to replace a CO detector according to the manufacturer's instructions or every 5 years. Both alarms covered above give an end-of-life signal when their time is up.

Does a smoke alarm detect carbon monoxide?

A standard smoke alarm does not. You need a separate CO alarm or a combination smoke and CO alarm.

Do I need a CO alarm if my home is all-electric?

If you have an attached garage, run a generator during outages, or have a fireplace, yes. Even with none of those, local building codes may require one; check with your local building department.

How we researched this

This is a research guide, not a hands-on test. Placement and maintenance guidance comes from CDC, CPSC and NFPA pages checked October 17, 2026. Product details come from the two Amazon listings named above on the same date; we did not buy or test these alarms. We rechecked the First Alert model code on First Alert's own page on November 6, 2026. The two images are original diagrams made for this article.

Sources